ICT cc6000 - Page 76

76
« Tube H/L Sensor Error ： A »
Code: E25
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
« Tube H/L Sensor Error ： B »
Code: E26
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
« Tube H/L Sensor Error ： C »
Code: E27
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
Tube A Sensor
Error E25
Tube B Sensor
Error E26
Tube C Sensor
Error E27