ICT cc6000 - Page 77

77
« Tube H/L Sensor Error ： D »
Code: E28
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
« Tube H/L Sensor Error ： E »
Code: E29
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
« Tube H/L Sensor Error ： F »
Code: E30
LED Light Display: None
LCM Display: As shown in figure below
Cause: Low Level = empty, Hi Level = full. Coin might be sorted to wrong tube.
Corrective Measure: Changer retries every 2 seconds during the standby mode.
Remove the stuck coin then restart changer to solve the problem.
Tube D Sensor
Error E28
Tube E Sensor
Error E29
Tube F Sensor
Error E30