Innovative Circuit Technology Ltd. 19
E-mail Setup
Configure these settings to enable automatic e-mail notifications directly
from the PDU. The information required for this is available from your
Network Administrator, or Internet Service Provider. (ISP)
E-mail:
SMTP Server: Enter the name or the IP address of your SMTP server used for
sending outgoing e-mail. (e.g. “smtp.gmail.com”)
SMTP Port: Enter the port used by your SMTP server. (Normally 25)
SMTP Server requires SSL: Check this box if your SMTP server requires an
encrypted SSL connection.
This box should normally be checked if the SMTP port used by the SMTP
server is 465.
If the SMTP server uses STARTTLS (normally port 587), this box should be
unchecked.
Sender E-mail Address: Enter an e-mail address that will appear as the
sender for all e-mail notifications sent from the PDU.
Recipient E-mail Addresses: Enter one or more e-mail addresses that are to
receive all e-mail notifications from the PDU. Use commas to separate
multiple addresses. This field can also be used to send a text message
notification to a phone; see the Text Message Alarm Notifications section
for further information.
SMTP User Name: Enter a SMTP user name here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
SMTP Password: Enter a SMTP password here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
Minimum E-mail Interval: Specify a minimum interval required between e-
mail notifications. (Default 1 minute, range 0 to 60 minutes) This time
interval is used to prevent an un-intended flood of e-mail alarm notifications
that could occur when an alarm limit is incorrectly configured, for example.
General E-mail Notifications:
Select these options to receive an e-mail when one or more of these events
occurs.
The Distribution Panel restarts: Check this box to receive an e-mail
notification when the PDU restarts after a power failure or a soft reset.