IDE e1.01 - Paid Time Counter

Time delays counter
Time delays counter (deletable) shows total time delays since the last
deleting.
Counter’s capacity: <0000h00m ; 9999h59m >
Default setting: 0000h00m
To browse and/or delete time delays counter contents:
1. When the controller is in the programming mode (see page 5), in the
Counters submenu (see page 8), select time delays counter with
buttons. Time delays counter
2. Press button. Time delays counter
3. To delete time delays counter contents, press button.
4. To delete time delays counter contents, press button. To stop
deleting counter’s contents, press button.
To return to the Counters submenu, press button. To leave the
programming mode, press button or wait 60 seconds.
Paid time counter
Paid time counter (deletable) shows the total sessions time, set by the
user, since the last deleting.
Counter’s capacity: <0000h00m ; 9999h59m >
Default setting: 0000h00m
To browse and/or delete paid time counter contents:
1. When the controller is in the programming mode (see page 5), in the
Counters submenu (see page 8), select paid time counter with
buttons. Paid time counter
2. Press button. Paid time counter
3. To delete paid time counter contents, press button.
4. To delete paid time counter contents, press button. To stop
deleting counter’s contents, press button.
To return to the Counters submenu, press button. To leave the
programming mode, press button or wait 60 seconds.
and
and
symbol and its contents,
expressed in hours, is displayed alternately.
symbol and its contents,
expressed in minutes, is displayed alternately.
The changes of the counter’s contents are saved
automatically in the long term memory after the of
ventilation.
symbol and its contents, expressed in
hours, is displayed alternately.
symbol and its contents,
expressed in minutes, is displayed alternately.
The changes of the counter’s contents are saved
automatically in the long term memory at the beginning
of the session.
START
START
STOP
STOP
MENU
START
START
STOP
STOP
MENU
I.D.E. Systemy Elektroniczne 11
P
P
P
START
START
STOP
STOP
P
P
P
START
STOP
STOP
I.D.E. e1.01 sunbed controller
EN
PageVersion 1.1 07/2005
P
START
P
Part II Operating manual
2. Programming mode