IDE e1.01 - Clients Counter; Electric Energy Counter; Statistics

I.D.E. Systemy Elektroniczne 12
Clients counter
Clients counter (deletable) shows the total operating cycles since the
last deleting.
Counter’s capacity: <0000 ; 9999 >
Default setting: 0000
To browse and/or delete clients counter contents:
1. When the controller is in the programming mode (see page 5), in the
Counters submenu (see page 8), select clients counter with
buttons. Clients counter
2. To delete clients counter contents, press button.
3. To delete clients counter contents, press button again. To stop
deleting counter’s contents, press button.
To return to the Counters submenu, press button. To leave the
programming mode, press button or wait 60 seconds.
2.3.2.2. Statistics
In the Statistics submenu (see page 12) it is possible to browse and
delete the following counters:
Electric energy counter (see page 12);
Takings total counter (see page 13).
To access Statistics submenu:
1. When the controller is in the programming mode (see page 5), in the
Protected settings submenu (see page 7), select Statistics submenu
with buttons.
2. Press button.
To return to the Protected settings submenu, press button. To
leave the programming mode, press button or wait 60 seconds.
Electric energy counter
Electric energy counter (deletable) shows total power consumption
since the last deleting.
Counter’s capacity: <00000 ; 99999 > kWh
Default setting: 00000
and
and
symbol and its contents, is displayed
alternately.
The changes of the counter’s contents are saved
automatically in the long term memory at the beginning
of the session.
Electric energy counter contents are calculated on the
basis of values set in Lamps power consumption (see
page 17) and Fans power consumption (see page 18)
options.
START
START
STOP
STOP
MENU
START
STOP
MENU
P
P
START
START
P
STOP
START
STOP
I.D.E. e1.01 sunbed controller
EN
PageVersion 1.1 07/2005
Part II Operating manual
2. Programming mode