IDE e1.01 - Maximum Session Time; Maximum Time Delay; Programming Options; Step

I.D.E. Systemy Elektroniczne 14
2.1.2. Programming options
In the Programming options submenu (see page 14) it is possible to
browse and change the following options:
Step (see page 14);
Maximum time delay (see page 15);
Maximum session time (see page 15);
Ventilation (see page 16);
Price (see page 16);
Lamps end (see page 17);
Lamps power consumption (see page 17);
Fans power consumption(see page 18);
Stop fans (see page 18);
Stop lamps (see page 19);
External stop (see page 19);
Buzzer (see page 20);
To access Programming options submenu:
1. When the controller is in the programming mode (see page 5), in the
Protected settings submenu (see page 7), select Programming
options submenu with buttons.
2. Press button.
To return to the Protected settings submenu, press button. To
leave the programming mode, press button or wait 60 seconds.
Step
Range of setting: < 01.00 ; 10.00 > (min)
Default setting: 01.00
Step: 1 min
To browse and/or change step:
1. When the controller is in the programming mode (see page 5), in the
Programming options submenu (see page 14), select Step option with
buttons.
2. To change the setting, press button. Step setting
.
3. Set new value with buttons.
4. To save new setting in the temporary memory, press or
buttons.
To return to the Programming options submenu, press button. To
leave the programming mode, press button or wait 60 seconds.
and
and
and
Option is used for setting the session time (Operating mode, see page
4). Each button pressing increases the session time with Step
value. Each button pressing decreases the session time with Step
value.
The step symbol and step setting is displayed
alternately.
will be
displayed
START
STOP
MENU
START
START STOP
STOP
MENU
START
STOP
I.D.E. e1.01 sunbed controller
EN
PageVersion 1.1 07/2005
P
START
STARTSTOP
START
STOP
P
Part II Operating manual
2. Programming mode