Lamps end
Option is used to set time, after which the lamps in the sunbed should
be changed.
Range of setting: off - option deactivated < 10 ; 2550 > (h)
Default setting: off - option deactivated
Step: 10 h
When lamps counter 3 (see page 10) contents exceeds
lamps end setting. the controller during session signals
with sound signal the necessity of changing lamps.
To browse and/or change lamps end setting:
1. When the controller is in the programming mode (see page 5), in the
Programming options submenu (see page 14), select Lamps end
option with buttons.
2. To change the setting, press button. Lamps end setting
.
3. Set new value with buttons.
4. To save new setting in the temporary memory, press or
buttons.
To return to the Programming options submenu, press button. To
leave the programming mode and save new setting in the long term
memory, press button or wait 60 seconds.
Lamps power consumption
Range of setting: < 00.00 ; 50.00 > (kWh)
Default setting: 00.00
Step: 00.05 kWh
To browse and/or change lamps power consumption setting:
1. When the controller is in the programming mode (see page 5), in the
Programming options submenu (see page 14), select Lamps power
consumption option with buttons. power
consumption power consumption
2. To change the setting, press button. Lamps power consumption
setting .
and
and
and
The lamps end symbol and the lamps
end setting is displayed alternately.
will be
displayed
Option is used to set the value, according to which the controller will
calculate the electric energy counter contents (see page 12).
If the sunbed is equipped with additional devices (for
instance air conditioning), their power consumption
should be added to the total body and face lamps power
consumption.
The lamps
symbol and the lamps setting is
displayed alternately.
will be displayed
START
START STOP
STOP
MENU
START
I.D.E. Systemy Elektroniczne 17
P
START
STARTSTOP
START
STOP
P
PageVersion 1.1 07/2005
I.D.E. e1.01 sunbed controller
EN
P
START
STARTSTOP
Part II Operating manual
2. Programming mode
To Next Page
Loading...