IDE e1.01 - Buzzer; No Code Access

I.D.E. Systemy Elektroniczne 20
To return to the Programming options submenu, press button. To
leave the programming mode and save new setting in the long term
memory, press button or wait 60 seconds.
Buzzer
Option is used to turn on and off sound signals in the controller. Buzzer
signals each button pressing in the controller and the end of ventilation
with sound signal.
Range of setting: no - option deactivated;
yes - option activated
Default setting: yes
To browse and/or change buzzer setting:
1. When the controller is in the programming mode (see page 5), in the
Programming options submenu (see page 14), select Buzzer option
with buttons. buzzer buzzer
2. To change the setting, press button. buzzer
buzzer
To return to the Programming options submenu, press button. To
leave the programming mode and save new setting in the long term
memory, press button or wait 60 seconds.
2.3.3. No code access
In the No code access submenu it is possible to browse and change
the accessibility of the following counters:
Lamps counter 1 (see page 9);
Lamps counter 2 (see page 9);
Lamps counter 3 (see page 10);
Fans counter (see page 10);
Time delays counter (see page 11);
Paid time counter (see page 11);
Clients counter (see page 12);
Electric energy counter (see page 12);
Takings total counter (see page 13).
Range of setting: no - counter deactivated;
yes - counter activated
Default setting: no
Counters activated in the No code access submenu are
available in the Counters presentation submenu (see
page 7) . In the Counters presentation submenu it is only
possible to browse the counter’s contents, without the
possibility of deleting their contents.
In a case of changing the external stop setting from “no”
into “yes”, reset the controller by turning off and on the
power supply.
The symbol and the setting is
displayed alternately.
The symbol and the
new setting is displayed alternately.
and
STOP
MENU
START
STOP
MENU
P
P
START
PageVersion 1.1 07/2005
I.D.E. e1.01 sunbed controller
EN
P
P
P
P
P
P
P
P
START
STOP
P
Part II Operating manual
2. Programming mode