4
Tilt-A-Way HYJG 1
GENERAL INFORMATION
Tilt-A-Way HYJG vertical pivot gate operates on various voltages. They are 240-vac single
phase, 240-vac three phase, 480-vac three phase, or 24-vdc. If the gate operates on 24-vdc it well
need two 12-vdc batteries (batteries not included). We recommend two 12-volt dc maintenance
free lead acid deep cycle series 27 battery 85 amp hours or equivalent. The two 12-volt batteries
are wired in series to supply 24 volts to the control boards. The wiring harness is equipped with
ring terminals designed to connect to bolt type battery post (red wire to positive and black wire to
negative). See wiring diagram on page 9 of this manual. Do not reverse battery polarity at the
battery or circuit board. Severe damage will occur. Disconnect the battery and all power sources
before installing any devices. Do not perform any welding while the motor cable is connected to
the control board or the battery connected. Serious damage to the control board and battery will
occur.
Caution – Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the batteries manufactures instructions.
Tilt-A-Way HYJG vertical pivot gate has a programmable control board, which allows numerous
programmable functions in various combinations (see programming section at in this manual).
The control board has Position Feedback. If the gate reverses direction twice and stops because of
the Position Feedback the control board will have to be UL reset.
A battery charger is supplied to keep the batteries charged on the 24-vdc model. See charger
owner’s manual for proper operation.
A qualified technician should check, and adjust all safeties monthly. The balance of the barrier
should also be checked, and adjusted monthly by a qualified technician.
Tilt-A-Way HYJG vertical pivot gate is supplied with two entrapment protection devices. Type
A, inherent entrapment protection system, manufacturer by Polytron on the logic control board
part number PEO202L. Type B2, contact-sensor edge, manufacturer by ASO Safety Solutions,
model 25.30. Both of the entrapment protection devices must be connected and functioning
properly before the gate operator is put into service. This is the maximum number of entrapment
protection devices to be connected to the operator.
Tilt-A-Way HYJG vertical pivot gate must be installed in a location so that enough clearance is
supplied between the gate and adjacent structures when opening and closing to reduce the risk of
entrapment.
To Next Page
Loading...
Need help?
General