MANUAL P/N:118253 PRINTED: 6/12/19
8. Glossary
1-wire Proprietary communication method that uses only one wire for data transfer.
C1 Class 1
CAN Controller Area Network. SAE J1939 communication method.
EEPROM Electrically Erasable Programmable Read-Only Memory. The memory of the tank level display,
used to store the display information (tank level points, display type, dim value, etc).
ESD ElectroStatic Discharge.
Foam A Class “A” type foam used when fighting fires where the cooling effect of water is of prime
importance in extinguishing (wood, paper, etc.)
Foam B Class “B” type foam used when fighting fires involving flammable liquids where blanketing or
smothering effect of water is of prime importance in extinguishing (gasoline, etc.)
IP Ingress Protection (IP 67, etc).
ITL Intelli-Tank Level. Class 1’s 4 and 5 light tank level display.
ITL40 Intelli-Tank Level 40. The tank level display.
LED Light Emitting Diode. The lights on the display used to show tank level and information.
MASTER Master display. The tank level display wired to the sensor. This display transmits data to other
remote displays.
NPT Normal Pipe Taper. Pipe thread specification.
OEM Original Equipment Manufacturer.
PCM Pump Control Module. Class 1 module p/n 111097.
P/N part number
PSI Pounds per Square Inch. Pressure measurement.
REMOTE Remote display. A tank level display that receives data from the master unit. The remote display
will only display what the master display commands.
SAE Society of Automotive Engineers.
Sensor The pressure sensor.
System voltage The normal power level used by the system or vehicle. This voltage level will normally come from
the vehicle’s battery and charging system (vehicle ignition, vehicle power, etc.)
TBD To Be Developed.
To Next Page
Loading...