CardioPet* ECG Device 8
Preparing the patient and attaching clips
To prepare the patient and attach clips:
1. Place the animal on a padded surface in right-lateral recumbency.
Note: The patient can also stand upright or be in sternal position; however, be sure to note these
positions in the patient history when you submit the case.
2. Liberally apply alcohol to each limb, 1”–2” below the elbows and knees.
3. Attach the CardioPet* Comfort Clips, being sure to part the fur for good skin contact.
Black: Left front leg Red: Left rear leg
White: Right front leg Green: Right rear leg
IMPORTANT: Make sure that the patient’s limbs, the cables, and the clips do not touch one other or touch
metal. For more information, review or print this poster that explains how to prepare a patient for an
electrocardiogram (ECG).
To attach clips for a chest lead ECG:
A chest lead may be helpful if the P-waves are indistinct in lead II.
1. Place all clips as described in the previous section, except the black clip.
2. Place the black clip on the left side of the chest between the fourth and fifth ribs, wherever the heartbeat
is strongest with touch or auscultation.
When you record an ECG with the clips in this position, lead I will appear as the chest lead.
3. Add “Chest lead included” in the patient history when you submit the case on vetmedstat.com.
To Next Page
Loading...
Need help?
General
