CardioPet* ECG Device 9
Maintenance and specifications
Cleaning and maintaining the CardioPet device
Clean the exterior of the device using a paper towel moistened with isopropyl alcohol.
Replacing and recycling batteries
• The CardioPet device uses two AA alkaline (nonrechargeable) batteries.
• Remove the batteries if the device will not be used for an extended period.
• To monitor battery status, note the battery indicator in the CardioPet software menu bar:
Battery life is adequate Battery change is needed
•
This symbol is placed in accordance with the European Union Directive 2002/96 on Waste Electrical and
Electronic Equipment (the WEEE Directive). If disposed of within the European Union, this product
should be treated and recycled in accordance with the laws of your jurisdiction implementing the WEEE
Directive. For additional information, visit idexx.com/weee.
Specifications
CardioPet device:
• Sampling rate: 500 Hz each channel
• Signal frequency range: 0.05 Hz to 100 Hz
†
• Filter type: Digital
• Channels: 2 according to 3 or 6 vectors
• Operating range: Approximately 100 m
(clear range)
• Operating temperature: 8°C to 45°C
(46°F to 113°F)
• Ambient relative humidity: 25% to 80% without
condensation
• Atmospheric pressure: 700 hPa to 1070 hPa
†
The frequency range refers to the CardioPet device. The resulting frequency range depends on the specific filters
implemented in the software.
Batteries:
Chemistry: Alkaline (zinc-carbon dry cell)
Type: AA
Rechargeable: No
Weight: 23 g
To Next Page
Loading...
