idronaut Ocean Seven 310 - The Main Menu

SECTION TWO- INSTALLATION AND START-UP
IDRONAUT – Brugherio (MB) OCEAN SEVEN 310 CTD 01-2019
23
PwrExt [3.72]VDC Batt.[3.24]VDC
PwrInt iT[10.7]C uP[3.19]VDC Vref[3.34]
If one (or more) of the start-up procedures is unsuccessful, an explanatory error message will be shown.
In this case, the probe will automatically accomplish the restoring procedure by itself.
The probe operating modes can be:
Start-Up (OPERATOR) Verbose
or
Start-Up (OPERATOR) Non-Verbose protocol [PTP]
If the probe is operating in “Verbose” mode, at the end of the above message, the probe “Main Menu”
appears; otherwise, if the probe is operating in “Non Verbose” mode, at the end of the above messages,
it will show the following message, waiting for instructions.
Start of Non-Verbose Point To Point protocol--
--return to the verbose mode by means of—
--<VT^J> command where: ^= CONTROL KEY PRESSED--
ER 000
Details about the PTP protocol and the relevant command and communication protocol rules can be
found in the “OCEAN SEVEN 3xx probes Data Transmission Protocol” manual. The manual can be
freely downloaded from the IDRONAUT web site “http://www.idronaut.it”. To switch the probe to
verbose mode, type the VT characters followed by the CTRL-J sequence (keep pressed the CTRL key
while typing the J character). Alternatively, use the “Identify” function available under the “PROBE”
menu of the ITERM programme.
2.4 THE MAIN MENU
At the end of start-up, when the probe initialization process is completed, the probe main menu appears:
OCEAN SEVEN 310 - ID:0317003 {USR}(1.0_10 05/17)Oct 01 14:55:23.95 2016
<0>[SHUT]-Shutdown
<1>[DATA]-Data acquisition
<2>[MEMO]-Memory
<3>[CALB]-Calibration
<4>[SERV]-Service
<5>[OPMD]-Non-Verbose mode
cmd>
<0>[SHUT] This command starts the "SHUTDOWN PROCEDURE" which saves the probe status
and powers OFF the probe. To complete the shutdown software procedure, please
rotate the probe magnetic switch and the deck unit power on switch to OFF position.
<1> [DATA] This command gives access to the data acquisition menu.
<2> [MEMO] This command gives access to the memory management menu.
<3> [CALB] This command gives access to the calibration menu.
<4> [SERV] This command gives access to the service menu.
<5> [OPMD] This command allows the operator to immediately switch the probe from "VERBOSE
MODE" to “NON-VERBOSE MODE". The probe automatically wakes up and starts up
with the last operating selected mode.
[ESC] Enter the probe in “LOW POWER CONSUMPTION MODE". Whenever the probe is in
“LOW POWER CONSUMPTION MODE", the prompt command disappear.