Do you want to terminate the Conditional data acquisition ? (Y)es (N)o
Pressing <Y> for Yes immediately terminates the conditional data
acquisition cycle. By pressing <N> for No, the probe immediately starts
an automatic power OFF procedure calculating the next sensor
monitoring time. The operator has 30s to answer the question. If no
answer is received, the probe shuts down by itself going on with the
conditional cycle.
Data acquisition error In case the probe does not complete a data acquisition procedure due
to hardware or sensor problems, the following message appears:
Error during data acquisition
After this message is displayed, the conditional data acquisition is
automatically concluded. Acquired data is automatically confirmed in
the probe memory.
To Next Page
Loading...
