the probe is OFF and answering positively to the question about the
intention of concluding the continuous acquisition cycle. In this case,
the following message appears on the PC screen at the end of the probe
start-up.
Do you want to terminate the Continuous data acquisition ? (Y)es (N)o
Pressing <Y> for Yes immediately terminates the continuous data
acquisition cycle. By pressing <N> for No, the probe continues the data
acquisition. The operator has 30s to answer the question. If no answer
is received, the probe shuts down by itself going on with the continuous
cycle.
Data acquisition error In case the probe does not complete a data acquisition procedure due
to hardware or sensor problems, the following message appears:
Error during data acquisition
After this message is shown, the continuous data acquisition is
automatically concluded. Acquired data is automatically confirmed in
the probe memory.
To Next Page
Loading...
