18 IDS1600 USER MANUAL NO. 700-146-01D ISSUED NOV 2002 VER 2.17
IDS1600 USER MANUAL
6. Zone Bypassing
The term BYPASS is used to describe a zone that has been de-
activated; i.e. violation of a bypassed zone will not cause an
alarm.
It is used when access is needed to part of the protected area
while the system is armed.
Zones cannot be bypassed once the system is armed.
Bypassed zones are automatically cancelled each time the
system is disarmed and must be re-bypassed before the next
arming.
6.1 To Bypass a Zone
Hold down [9] + [ZONE NUMBER] + [] + [#]
1. Hold down the [9] key until the keypad buzzer sounds to enter
bypass mode.
2. Press the number corresponding to the zone you need to by-
pass e.g. the [2] key if you wish to bypass zone 2, then press the
[] key.
3. The relevant zone indicator will illuminate to indicate that the zone
is now bypassed.
4. Repeat step 2 to bypass any other zones.
5. Press the [#] key to exit the bypass mode.
NOTE:
Some zones may be programmed to function in a manner which does
not permit bypassing e.g. Panic zones.
6.1.1 Bypassing Zones using the LCD Keypad
1. Hold down the [9] key until the keypad sounds.
B Y P A S S MO D E
MRA ELBUORT
2. Press the [MODE/ menu >] key.
To Next Page
Loading...
Need help?
General
