26 IDS1600 USER MANUAL NO. 700-146-01D ISSUED NOV 2002 VER 2.17
IDS1600 USER MANUAL
[#] is pressed.
6. The alarm memory will be erased the next time the system is
armed.
11. User Codes
The IDS1600 Alarm Panel has 64 programmable user codes.
Code 1 : Master User Code which is active in all partitions
Codes 2 - 64: General User Codes for all partition.
NOTE:
All codes are, by default, assigned to all partitions.
11.1 Entering New / Changing Existing User Codes.
[] + [MASTER USER CODE] + [] + [CODE NUMBER] + [] + [NEW CODE] + []
NOTE:
User Codes can only be changed if the code is valid in the current
partition.
1. Hold down the [] key until the keypad buzzer sounds.
2. The ARMED and READY indicators will flash alternately,
indicating that the system is in the mode which allows
programming of user codes.
3. Enter the [MASTER USER CODE] (the factory default is 1234)
followed by the [] key.
4. The ARMED and READY indicators will begin to flash
simultaneously indicating that the correct master code was
entered. If an invalid code was entered the keypad buzzer will
beep three times.
5. Enter the [USER CODE NUMBER] you wish to change (1-64)
followed by the [] key.
6. Enter the new 4 digit [USER CODE] and press the [] key.
7. Repeat steps 5-6 to enter or change other user codes.
8. Once all the codes are programmed, press the [#] key to exit.
To Next Page
Loading...
Need help?
General
