IDS1600 USER MANUAL NO. 700-146-01D ISSUED NOV 2002 VER 2.17 23
IDS1600 USER MANUAL
[] key.
3. Proceed as if the keypad was assigned to this partition.
NOTE:
If the ARMED indicator remains illuminated, the wrong user code has
been entered. Press the [#] key and re-enter your code. Four
successive incorrect codes will result in the keypad locking you out for
30 seconds. During this time any code will be treated as incorrect.
7.3 To Disarm with a Key-Switch or Remote Control
This option is not standard; check with your installer to verify if this
feature is enabled.
1. Press the remote button or twist and release the key-switch.
2. The system will disarm and the remote indicator (if installed) will
extinguish.
3. If programmed to do so, the siren will sound briefly - verify with
your installer.
8. Emergency Situations
8.1 Fire Alarm
[F]
(Hold down the key until the keypad buzzer sounds)
If the [F] key is pressed until the keypad beeps (approximately 1
second) a FIRE ALARM condition will be activated.
The FIRE ALARM CONDITION can also be triggered by a smoke
detector connected to an appropriately programmed zone.
The siren will sound and the FIRE REPORTING CODE will be
transmitted to the monitoring company.
To silence the siren enter a 4 digit [USER CODE].
To Next Page
Loading...