12
User Setup
How to Change Settings in the Setup Screens
To enter the setup screens, press the MODE button, and simultaneously
press FAN button for 5 seconds. Release the buttons when you see
“Setup” on the display. Use the UP or DOWN buttons to adjust the value
of your selection. Press MODE to advance to the next setup step. Press
MODE and FAN together again to leave the setup screens.
FANMODE
press together
for 5 seconds
TO ENTER MENUS BUTTON PRESS
Setup Steps MODE & FAN for 5 seconds
Time Schedule MODE & UP for 2 seconds
Emergency Heat UP & FAN for 2 seconds
Lockout Buttons MODE, UP & DOWN for 2 seconds
Calibration MODE & DOWN for 2 seconds,
then MODE
Wireless Setup FAN for 5 seconds unless running
time period program
Table for button
presses that are
required for
entering various
menus
To Next Page
Loading...
Need help?
General
