13
User Setup: Clock
Setting the Clock and Day (setup steps 1 & 2)
Note: When your thermostat is connected to Skyport Cloud Services, the
time and day of the week are controlled by Skyport. There is no local ad-
justment, Skyport also adjusts the time for Daylight Savings Time as well.
Setup steps 1 and 2 will not appear on thermostat if connected to Skyport.
To set the time and day when not connected to Skyport; enter the setup
screens by pressing the MODE button and simultaneously pressing the
FAN button for 5 seconds.
Setup step 1 adjusts the clock.
Use the UP and DOWN buttons to adjust the
time.
Press the MODE button to advance to step 2.
Select the day of the week using the UP and
DOWN buttons.
Leave the setup screens by again pressing
the MODE button and simultaneously
pressing the FAN button for 5 seconds.
Show Clock (setup step 3)
This setup step will allow for removal of the
clock and day of the week from the display.
OFF removes the time and day from the
display.
To Next Page
Loading...
Need help?
General
