18
Installer Setup
Maximum Override Time (setup step 16)
This feature limits the maximum override time
when using the OVERRIDE button 1 - 4 hours.
Fahrenheit or Celsius (setup step 17)
This feature allows the thermostat to display
temperature in Fahrenheit or Celsius.
Fan Auto Operation (setup step 18)
• ON = Continuous low speed fan
• OFF = Only energize with a heating or
cooling cycle
This step is useful when using a duct
sensor to keep airow for the sensor.
Fan Relay Type (setup step 19)
• NORMAL = Conventional 3 speed fan
coil system
• SPECIAL = IEC Fan Coil using
E025-71481103/4
Relay Board
Wired Sensor Type (setup step 20)
• RETURN, OUTDOOR, SUPPLY = the
sensor temperature is reported to
Skyport to monitor only
• REMOTE = the sensor can be used for
temperature control
To Next Page
Loading...
Need help?
General
