IEMCA KID 70 - Page 70

GB
6 - USE AND OPERATION KID 70
6 - Pag. 12 / 14
6.12 EMERGENCY STOP AND RESTART
INFORMATION:
Press lathe or bar feeder emergency button in case of impending ranger only.
Bar feeder and lathe operation will stop immediately. Restore ordinary operation
conditions then release button to allow the unit restart.
Carry out this operation following these instructions:
• Press this button
on the bar feeder to start bar feeder operation and holf it down
until it lights up.
• Pree this button
to select manual operation mode.
• Let bar feeder devices reach the cycle start position, when necessary.
• Pres rapidly this button twice
to set bar feeder zero.
• Press this button
to start the automatic cycle.
• The bar feeder now allows lathe machining.