6 - USE AND OPERATION KID 70
GB
6 - Pag. 13 / 14
6.13 STEP BY STEP
You will have to activate a "step by step" cycle if you wish to check bar feeder operating
conditions: it is possible to start either a complete opearating cycle or a partial cycle.
Complete cycle
Carry out this operation with or without bars.
• Turn selector switch
and hold it to the left; the bar pusher will reach its back
position.
• Turn selector switch
and hold it to the left; the bar selecting device, the bar drop
control device and the bar pusher are lifted.
• Turn selector switch
and hold it to the right; the bar drop control device is lowered
and the guide channel opens to allow the first feeding.
• Turn selector switch
and hold it to the right; the truck carries out the first feeding.
• Turn selector switch and hold it to the left; the truck returns to its start position.
• Turn selector switch
and hold it to the left; the error on the display will be removed
while the bar pusher and the guide channels close.
• Turn selector switch
and hold it to the right; to drive the bar pusher into the spindle
liner.
To Next Page
Loading...
