2.1.1.1 Connecting the Printer to the AC Power
WARNING
It is important to proceed in the order below:
- Make sure the printer is switched off (power switch set
to the 0-position).
- Plug the power cord (1) into the corresponding
connector at the rear of the printer.
- Connect the power cord to the line power outlet.
Note: The IER 400 Printer switches automatically to the available AC
line power within the authorized voltage range (see User Safety
Guide, IER P/N N0C4SEA, shipped with the printer).
IER 400B
User Guide
Page 16
N0C402B Rev. 1
July 6, 2009
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization
To Next Page
Loading...
