Ier 400B - Printer Maintenance Procedures; Recommended Maintenance Schedule

6 PRINTER MAINTENANCE
6.1 RECOMMENDED PERIODIC MAINTENANCE
Schedule: Every 2 weeks or after 2000 m of printing.
Estimated Time: 15 min.
Tools Required / Maintenance Products:- IER cleaning kit, ref. S32129A
WARNING
Before starting to clean the printer:
- unload the paper from the printer, see page 42
- switch off the printer,
- disconnect the printer from the power supply,
- disconnect the data cable.
6.1.1 Periodic maintenance frequency
To ensure optimum use of the printer under normal conditions, IER
recommends periodic cleaning every 2 weeks or after 2000m of
printing.
IMPORTANT: The frequency of cleaning must be adapted to the
specific environmental and operating conditions of the
printer (dusty atmosphere, paper quality, sustained
printer use, etc. ).
Use the IER cleaning kit, ref. S32129A following the instructions in
the kit, and applying the procedures described in this document.
CAUTION
IER declines all liability for incidents arising from failure
to follow its recommendations regarding service
intervals, products and procedures.
IER 400B
User Guide
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization
Page 45
N0C402B Rev. 1
July 6, 2009