6.2.2 Cleaning the Printhead and Platen
CAUTION
The printhead is a sensitive electronic component:
- put on an anti-static wrist strap before touching it,
- avoid physical shocks to the printhead,
- do not use any tools that could damage it,
- do not touch the printhead heating elements.
Proceed as follows, using the products in the IER cleaning kit and following
the enclosed instructions:
- Use one of the soft, lint-free cloths and moisten it slightly with the
recommended cleaning product to clean the platen surface (2); rotate the
platen (2) manually to have access to the entire platen surface (2).
- Using alcohol filled foam swabs, clean the whole surface of the printhead
heating elements (1).
IER 400B
User Guide
Page 48
N0C402B Rev. 1
July 6, 2009
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization
To Next Page
Loading...
