Ultrasonic flow meter SU2020 SU8020 SU2021 SU8021 SU2621 SU8621
23
– configuration of the parameters according to the function selected for [ou2]:
limit values for switching signal: SP2, rP2, FH2, FL2
pulse value for totaliser: ImPS2
switch point and reset for totaliser: ImPS2, rTo2
limit values for analogue signal: ASP2, AEP2
– [FOU2]: error behaviour of the output
6. [diS.L]: display layout
After the message that the guided installation is completed, you are asked whether you want to start
the measurement.
u Select [Yes] or [No] or [Device info].
w If [Yes] is selected, the installation process is completed and the unit changes to the process value
display.
w If [No] is selected, the parameters for the flow direction, OUT1/OUT2 and the display layout (steps
3...6) can be modified again, or the guided installation can be restarted from the beginning using
the [Restart Guide] command.
w If [Device info] is selected, the unit displays the previously set unit configuration.
To Next Page
Loading...
