10
5.3.3 PIP SEL
The double-screen display selector key is pressed to change the display in the order of
PinP1, PinP2, SBS1 and SBS2.
Switching operation is performed in the order stating from Single Screen → Multi-Preset
No. 1 → Multi-Preset No. 2 → Multi-Preset No. 3 → Multi-Preset No. 4. Carry out the
PIP setting (display setting) on the P-Pre Select Screen as described under 5.11.
Main Main
Sub Main Sub Main
Sub Sub
PINP1
Small sub-screen
display
PINP2
Large sub-screen
display
SBS1
Reduced full display
SBS2
Dot-by-dot display
5.3.4 SWAP
In the double-screen display mode, this key is used to switch between the main and sub
screens.
5.3.5 OSD Menu Operation
Press the MENU key, and the Status screen shown below appears. The tabs are selected
with the “+” or “-” key and fixed with the”MENU”key. The selected tabs change color. All
the new settings are saved by pressing the EXIT key once. Press the EXIT key again, and
the operation is completed. If no saving takes place, select UNDO, press MENU first and
then EXIT. The operation ends with the previous settings intact.
5. Operation
To Next Page
Loading...
