Ilsintech SWIFT K11 User Manual

Optical Fiber Arc Fusion Splicer
Read this user manual carefully before running K11
SWIFT K11
SWFIT K11-EN, Rev.A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Device Type
Notification
A Class Device
(Broadcasting and communication device,
commercial use)
Users need to understand that this device(A Class) has obtained
EMI(Electromagnetic compatibility) and been designed to be used in
places other than home.
USER MANUAL
WWW.ILSINTECH.COM

Ilsintech SWIFT K11 Specifications

General

Brand	Ilsintech
Model	SWIFT K11
Category	Heater
Language	English

Summary

1. NOTES FOR USERS

WARNINGS

Safety warnings regarding potential hazards during equipment use.

CAUTIONS

Precautions for safe operation and to prevent equipment damage or injury.

2. Product specifications and composition

4. Instructions for use

4.1 Power supply

5. Maintenance of splice quality

5.1 Cleaning and Inspection before splice

Procedures for cleaning and inspecting components before performing a splice.

5.1.1 V-Groove cleaning

5.1.2 Pusher Block cleaning

5.1.3 Cutter cleaning

5.2 Regular cleaning and inspection

Routine cleaning and inspection procedures to maintain splice quality.

5.2.3 Electrode replacement

7. Error message

7.1 Optical fiber is too dirty.

Error indicating foreign substances on the optical fiber during splicing.

7.2 Replace the optical fiber.

Error when optical fiber is misplaced or object lens/reflector is dirty.

7.3 Optical fiber is too long.

Error due to fiber too close to electrode, dirty lens, or insufficient LED brightness.

7.4 Error on angle of optical fiber

Error when the optical fiber's cutting angle exceeds the limit.

7.5 Loss is big.

Error indicating estimated splice loss exceeds the preset factor limit.

7.6 Optical fiber is thin.

Error when the sealed fiber is thinner than the standard.

7.7 Optical fiber is thick.

Error when the sealed fiber is thicker than the standard.

7.8 Bubble being generated

Error indicating bubbles or spots on the sealed optical fiber.

7.9 Error on cut surface on left, right or both

Error due to poor quality of the optical fiber's cut surface.

8. Sealing problem solving

8.1 When loss is big

Troubleshooting steps for scenarios where splice loss is excessively high.

8.2 Abnormal sealing operation

Solutions for repeated arrayal or continuous 'Optical fiber is too long' errors.

9. Problem occurrence and question

9.1 Power

9.2 Splice

9.3 Sleeve heater