SWIFT K11-EN, Rev.A 75
9. Problem occurrence and question
9.1 Power
Power is not turned on by pressing .
Check whether the screen is turned off with the switch being pressed for about 1
second.
Splice can be done several times even with the fully charged battery.
Power is quickly consumed when sleep mode is not in use. Refer to the [sleep
mode] and use the power appropriately at all times. When the battery is kept for
long, recharge it.
If the battery’s life ends for long-term use, replace it with a new one. As the
battery operates using chemical reaction, its wattage drops with low temperature
and it rapidly drops particularly with temperatures below zero. As the splice
current consumption goes up with high temperature, battery’s power
consumption accelerates.
LED is not turned on upon charging.
Disconnect the charter’s AC power cord and connect the DC cord to the charging
jack. Connect the AC power cord after 10~15 seconds. Then the battery’s LED is
turned on red and charging starts.
Remaining battery is not indicated.
Charge the battery.
Remaining battery is not well displayed.
Remaining battery display is for reference.
To Next Page
Loading...
