Ilsintech SWIFT K11 - 9.3 Sleeve heater

SWIFT K11-EN, Rev.A 77
 I’d like to set pause.
Refer to [Option menu].
 I’d like to indicate cutting angle, optical fiber’s angle and core/clad deviation.
Refer to [Option menu].
 Estimated splice loss and measured splice loss does not match.
The estimated splice loss is a calculated value so it should be used only as a
reference.
9.3 Sleeve heater
 Optical fiber protecting sleeve is not contracted completely.
Increase the heating time. Refer to [Heater mode edition].
 Heater is overheated.
Stop the heater by pressing , turn the power off and then contact to
Ilsintech.
If the protecting sleeve melts and it sticks to the heater cover, remove it by
pushing with cotton swab.
 I’d like to initialize heater mode’s heating condition.
Refer to [Heater mode edition].
 I’d like to cancel heater in the middle of operation.
Heater operation cannot be canceled
by pressing . Cancel it by pressing once again.