SWIFT K11-EN, Rev.A 24
4.10 Separation of connected optical fiber
i. Open the cover of sleeve heater.
ii. Open the windbreak cover.
iii. Hold the optical fiber on the left and open the clamp on the left.
iv. Open the optical fiber clamp on the right.
v. Hold the both sides of spliced optical fiber and separate optical fiber from Swift K11
with care.
4.11 Heating for protecting sleeve
i. Move a splicing point to the center of protecting sleeve. Make the protecting support
of sleeve face the bottom.
ii. Place the protecting sleeve at the center of sleeve heater.
iii. Hold the both sides of optical fiber and pull downwards as shown in the figure and the
heater cover is automatically closed.
iv. Heating starts by pressing .
v. LED is turned off when heating completes.
vi. Open the heater cover and separate optical fiber. Do not touch protecting sleeve or
heater right after the heating.
vii. Conduct final inspection on whether there are bubbles, fragments or dusts on sleeve.
To Next Page
Loading...