TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 400/60 AFI-Eing ED.2011 rev.00 16/60
It is not suitable to cut wood and similar materials (see D.M. 2006/42/CE, enclosure I, paragraph 2.3).
The automatic cycle is comprised of: clamping the material, feeding and cutting, sawframe return and unclamping
of the material. The operator has to adjust the cutting parameters, the sawframe rotation for miter cutting and to
load a new bar at the end of each cutting cycle. The feeder strokes, the cutting lengths and the number of cuts are
programmed by means of the keyboard.
The Safety Norms and the Directives applied are mentioned in the enclosed Declaration of Conformity.
From the working position in front of the saw - WORKING AREA - the operator can activate all drivers, check the
correct working of the saw and avoid dangerous areas.
In the following paragraphs you will find all information for using the machine in the best way and for a very long
time.
13 - MACHINE SETTING FOR STARTING
Verify that machine does not have damages or faults and check the standard equipment which includes tools,
fittings to perform some adjustments, user’s book.
In case the machine is supplied with additional equipment, make sure it is suited to the machine. Point out promptly
possible damages or faults to the reseller or to the service staff before running the saw.
Remove the locking bracket between the sawframe and the basement and put it in the left side of the floor stand -
11/RI0464 - Remove the protective elements placed on the machine in order to safeguard it when shipping it and
handling it, by using proper objects or paper. Check also that there is no rust on the metallic parts.
In case compressed air jet is used, always wear proper eye protection.
Take out the chip collector tank located in the back – 5/RI0464 - by unhooking it from the guides, then remove
possible objects inside which can hinder the coolant flow.
The parts in motion (band guides, trolleys, hinges, bearings, and so on) are already lubricated, the gear box
contains the precise quantity of oil needed to work. The hydraulic system is ready to start.
To Next Page
Loading...
