TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 400/60 AFI-Eing ED.2011 rev.00 13/60
11 INSTRUCTIONS FOR USE AND WARNINGS
This bandsaw can carry out cutting cycles, at the end of which the material that has been cut has to be removed
and if necessary the cutting conditions have to be changed = SEMIAUTOMATIC CYCLES
It can also perform autonomous cutting cycles, including the feeding of the bar until it has been completely cut =
AUTOMATIC CYCLES
Thus the machine can be driven by the operator or carry out a cutting cycle automatically, which ends when the
machine stops. The starting procedure has to be repeated to begin a new one.
11.1 - This machine is designed and manufactured so as to be safely used by the operator, provided that it is
properly run. No protections will ever suffice if the operator does not work with caution, does not make sure that the
machine is in top working conditions and does not follow the instructions below.
Don’t forget that this bandsaw is designed to CUT METALS with a proper tool, and that you are responsible for a
SAFE and CORRECT use. You must :
1. check that the machine is properly installed and electric supply is suited.
2. be sure to learn all main features of the saw before running it.
3. do not expose yourself or any other people to any risk.
4. wear personal protective equipment
5. do not remove or modify the SAFETY DEVICES installed by the manufacturer, make sure that they are always in
a good condition, too.
6. follow a regular maintenance schedule and check regularly the efficiency of the saw.
7. never use tools with unsuited characteristics
8. do not try to cut material with a size bigger than the cutting capacity of the machine
9. Keep the cutting area clear of tools or other loose objects.
10. do not run the saw unless all guards and protections are in place
11. NEVER WEAR loose clothing, long sleeves, large gloves, jewellery, or any other items that may get entrapped
into the machine
12. Always disconnect the power supply when performing maintenance or making adjustments.
13. do not get close to the cutting area with your hands or any other part of your body when the saw is running
14. Clamp properly the material in the vice and never hold it with your hands
15. Support appropriately the bar from both sides to prevent it from falling
We recommend to install a roller table on the unloading side in case the cutting length of the bar is
bigger than the distance between the blade and the right side of the basement
16. When cutting very short pieces, make sure they do not jam into the blade.
17. If the blade remains entangled with the material, stop the machine, open the vice and remove the material, then
check the condition of the blade and the teeth: if they are damaged or broken, change the blade
18. Apply a constant pressure during the cut
19. Do not move the saw during the cut or cause instability
20. Wear personal safety equipment when running the machine
ALWAYS RUN THE SAW SAFELY, USING COMMON SENSE AND ALERTNESS
To Next Page
Loading...
