TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 400/60 AFI-Eing ED.2011 rev.00 1/60
1-
We recommend to read carefully the information here included in order to install, use and maintain correctly and
safely this machine.
Please refer always to this instruction manual in case of assistance service need and keep it carefully for all the
machine life. PLS CALL +39035438791835 or + 390354387928 , taking note of the serial number of machine.
A consequence of the continuous improvement of the product is that some images/descriptions here included could
not correspond to the improved features of the machines.
Your kind collaboration would help us in intevening asap.
In the enclosed Compliance Declaration you will find the Safety and Reference Norms applied during the planning
and construction of this machine.
The choice and the use of the parts have been made by considering the conditions of use and the long machine life.
The identification plate, with the serial number, is fixed on the front right angle of the base or on a side of control
box.
1.1 - ATTACHED DOCUMENT FOR E.M.C. ( INDUSTRIAL ENVIRONMENT)
The user is responsible for the installation and use of this machine in compliance with the manufacturer's
instructions shown in this manual. This equipment meets the protection requirements in accordance with the
Directives 2006/42/EEC, 2004/108/CE for Electromagnetic Compatibility (EMC). In particular, it follows the
technical guidelines of the Directives EN55011, EN50082-2 and it has been made for industrial and not for
household use.
In the event of electromagnetic interferences the user is responsible for solving the problem with the help of the
technical assistance by the manufacturer. Before installing the machine the user must take into account possible
electromagnetic problems of the working area. In particular, we suggest to install the machine away from:
-signalling, control and telephone cables;
-radio-television transmitters and receivers;
-computers or controlling and measuring instrument;
-safety and protection devices.
The electric supply cable must be kept as short as possible, without any twists.
Covers, doors and the frame must be suitably closed when the saw is operating.
Under no circumstances the machine must be modified except for adjustments and changes specifically approved
by the manufacturer. Follow the maintenance schedule.
To Next Page
Loading...
