TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 400/60 AFI-Eing ED.2011 rev.00 32/60
15. THE BLADE IS SIGNED OR SCRATCHED ON
ONE SIDE
- Check the wear and tera of band pads;
- the pads press too much against the band back;
- check the alignement and the perpendicularity of the
band guides.
16. BURR OR SWANGING ON THE BAND BACK
- Increase the tension and adjust the band guides;
- check the pressure and the alignement of the thrust
bearings on the band back;
- reduce the cutting pressure;
- use a bigger toothing.
17. THE CUT PIECE HAS BLACK DIRT
- The band back touches the lip angle and becomes
dirty;
- if the dirt is on the left side: the left band guide is
out of axle;
- if the dirt is on the right side: the right band guide is
out of square;
- the dirt is on the complete cutting line: the band
guides are out of square, or: the pressure is too high;
the band tension is too low; teeth are too thick and
cannot set free from the dirt; the used coolant is
wrong
22 - MACHINE DEMOLITION
This paragraph may give some informations about the macrooperations of machine disassembly for its
scrapping.
Special procedures are not required but it is necessary to take only some cares to avoid damages in the last phase
of the machine life.
Generally: you must empty the cooling installation tank, take out the oil from the reduction box, from the hydraulic or
hydropneumatic installation. Lock the parts that could move and cause danger or instability.
Remove the parts assigned to the differentiated draining, for example the printed circuit, display stations,
programming keyboards, buffer batteries and so on, especially the ones which shows the picture ..In these
cases, in relation with the WEEE/AEEE Regulations ask to the supplier to know the right process, that depends by
the machine size and purpose.
23 - SPARE PARTS
The choice of the required spare parts is aided by the included drawings that allow, together with the working
schemes, to know better the machine.
17.1 - NORMS TO REQUEST THE SPARE PARTS
It is necessary to inform the TECHNICAL SERVICE about the following data:
- the serial number indicated on the identification plate
- model, version, type
- voltage and power frequency
- code number of the spare-parts
- requested quantity
- possibly the fittings assembled later
17.2 OILS AND LUBRICANTS (Comparison table marked RI0108):
To Next Page
Loading...
