IMO Oko 2000 - Cleaning; Preparation; Removing the Washed Load

3.6 Cleaning
IMO GmbH Gässlesweg 6 D-75334 Straubenhardt Tel.: 070 82 491 80 Fax: 604 36 www.imo-ag.com info@imo-ag.com
10
GmbH
- Open the front door
- Dosage of the cleaning agent (see item 3.4)
- Place the frames carrying the circuit boards into the washing space
1. Preparation
- Close the front door
- Switch on ÖKO 2000
- Select “start program” and confirm
- Use pointer up / pointer down to select the required program
- Confirm the required program with “ENTER”
- Machine begins to run; the program sections are indicate on the display
- Finish message after the end of the cleaning program
2.Cleaning
- Switch off the machine
- Open the front door
- Remove the wash frames with the circuit boards from the wash space
Warning: washed load is hot!
- Close the front door
3.Removing the washed load
Please note:
The machine works only when the front door is closed properly. To open the front
door immediately interrupts the program sequence. This is indicated by flashing on
display. During the heating-up phase the display shows the elapsed time of
cleaning or rinsing as follows: ‘--’ . After the temperature has reached its debit, the
programed time starts. The elapsed time is shown on the display.