4.3 Program new / alter
IMO GmbH Gässlesweg 6 D-75334 Straubenhard t Tel.: 070 82 491 80 Fax: 604 36 www.imo-ag.com info@imo-ag.com
12
GmbH
Present cleaning program:
Can be altered
Empty storage space:
Inclusion of a new cleaning program is possible
Press / to select number of new program /
to alter existing program
Use for editing mode
Attention: Numbers of program 1-20 possible.
By selecting and using / several pages can leaf through.
Attention: If the actually step is emtpy, it can’t be paged down.
Type of programm step: can be altered by selecting
Attention: possible types of programm:
cleaning
rinsing
drying
empty
(cleared)
Type of program step ‘cleaning’:
Required water temperature in the range of 20°C up to 70°C.
Current time in the range of 5 up to 40 minutes, after the required
temperature of water and required dosage of detergent.
Select for detergent with
Chose of dosage pump for program step (DOS1 or DOS2).
The assigned detergent is shown on display (see page 15).
Quantity of dosed cleaner in proportion to filled quantity of water
(not with foaming or defoaming detergent; see page 20).
Addition of cleaning powder: yes / no switched by .
If ‘ yes’ is adjusted, program stops and gives message for manual
dosage of cleaning powder.
a
a
a
a
a
programme new / alter
no. 2 engaged
no. 3 engaged
no. 4 empty
no. 5 empty
no. 6 empty
no. 7 empty
programme nr. 4
step no.: 01
type: empty
step No.: 01
type: cleaning
temperature: 30°C
duration: 5min
detergent: ==>
programme no. 2
DOS1: component A
quantity: 3,0%
add.
detergent powder: no
programme no. 2
or
To Next Page
Loading...