Force Displays:
19
Force
C1 098*120*142
Next/No C2 105*125*150
Next/No (All other channels)
CXL 110*124*140
1
2
CXM 115*125*135
(numbers are for example only):
Press Force. The display will show “C1
098*120*142” which means that the
force measurement for channel 1 is 120
and the machine will be stopped if that
number falls to 98 or goes up to 142.
(Remember that the numbers are
relative; they do not represent pounds or
tons). The middle number may change
with every stroke; the other numbers
will change most when IMPAX first
‘learns.’ These numbers are devised by
IMPAX based on the average force
value and the tolerance number entered
for that channel.
Press Next/No. The display will now
show “C2 105*125*150” which is the
force measurement for the next channel,
channel 2. Pressing Next always
advances the display to the next
channel; pressing Back returns to the
previous channel.
Press 1. The display for the channel
being shown will change to “C2L
110*124*140”. The first digit shows
that it is still channel 2, and the force
measurement (middle number) remains
approximately the same. The “L”
means that the measurement now shown
is a “Low Count” sample, which is the
average of a few successive blows.
Note that the middle number does not
change as often or as greatly as before.
Therefore the upper and lower limits
can be closer.
Press 2. The display will change again
to “C2M 115*125*135”. This is the
“Medium Count” sample for channel 2
(shown by “C2M”) which is an average
of sixteen (16) blows. The limits are
closer yet, and the middle number
changes even less than before.
Press Display Will Show
where X was the channel being displayed
where X was the channel being displayed
To Next Page
Loading...