I-Control manual page 12
Body weight (0 to 99,999 gr)
Enter the average bird weight. The I-Control calculates the total weight of the birds in the house.
Posology/kg (0 to 999.999 ml or gr)
This is the required amount of medicine per kg bird weight. This is dependent on the type of medicine.
Concentr. med (0 to 100%)
Enter the concentration of the medicine. This value is indicated by the manufacturer.
Water volume (0 to 999,999 l)
This function must be set at the number of liters of water to be supplied to the house to administer the medicine.
Setting the medicine pump (0 to 100%)
Enter the percentage of liquid to be added to the drinking water by the medicine pump. For example: setting at
5%. The medicine pump will add 50 ml of water + medication to each liter of drinking water. This value is indicated
on the medicine pump used.
Total weight (0 to 9,999.999 kg)
This function indicates the total weight of the birds. This value is calculated from the set values (see previous
functions). Note: The total weight is displayed in kg. If the value exceeds the kg limit, the display will automatically
switch from kilograms to tons.
Total medicine (0 to 9,999.999 ml)
This function indicates the required amount of medicine. This amount is calculated by the I-Control. Note: if the
value exceeds the ml limit, the display will automatically switch from milliliters to liters.
Water+medicine (0 to 999,999 l)
This is the amount of water in which the specified amount of medicine is to be dissolved. This will be added to the
drinking water by the medicine pump.
Filling water pipes
Select this menu by pressing the key in the main menu. Select “Filling water pipes” and press the key.
This menu allows the lines to be filled once with water and an optional medicine. The amount of water can be
adjusted per line. After the start signal, all the lines will be filled with a preset amount of water.
Mode filling (off – on)
With this function, a single filling of the lines can be started. Set to ON and all lines fill with the set number of liters.
If the filling is to be stopped, set to OFF. Note: If the I-Control is set at a given start and stop time, it is not possible
to fill the lines.
Liters, lines 1 to 10 (0 to 10,000 l)
With this function, the amount of water needed to fill the corresponding line can be specified. Note: When the
I-Control is set to fewer than 10 valves, the unused valves will not be displayed.
Tim
e after delay (0:01 to 23:59, hours:minutes)
After the completion of filling all the lines, there will be a waiting period during which there will be no flushing.
This function can be used when the lines are filled with water and medication. After filling, the solution remains a
given time in the lines and will not be rinsed away.
Max.fill time (1:00 to 60:00, minutes:seconds)
This function determines the maximum time allowed to fill a given line during the one-time filling. This can be
important, for example, if the water meter or valve is faulty. After the set maximum time, the next valve will
function.
To Next Page
Loading...