I-Control manual page 18
Default curve 1-5 menu
Select one of the default curve menus with the "Default curve x” option in the installer’s menu and press the
key. With this menu, the default curve of the I-Control can be set. The I-Control has 5 standard curves, which can
be changed. In the installer’s menu select “General” and choose one standard curves, which will be copied to the
user curve. The menu displayed indicates the standard curve for breakpoint 0. The other breakpoints are reached
by using the buttons
or . In this manner, breakpoints 1 to 5 can be set.
Starting time 1 (00:00 to 23:59 hours)
This is start time 1 for the respective breakpoint. 4 Start times are possible.
Note: Unused start times are set to 00:00.
Repeat day 1 (1 to 14)
This function determines the interval of days that start time 1 will be repeated.
Start times 2-4 can be set in the same manner.
The following standard curves are pre-set (the default setting is 2 minutes):
• Standard curve 1 = LAYING HENS
• Standard curve 2 = REARING
• Standard curve 3 = BROILERS
LAYING HENS: Every morning at 4:30 hours 2 minutes of flushing with no further breakpoints, etc.
REARING (to ± 18 weeks):
Day 1 to 4: 3 flushings per day at the following times: 5.00 hours / 13.00 hours and 21.00 hours
Day 5 to 10: 2 flushings per day at the following times: 5.00 hours and 17.00 hours
Day 11 to 20: 1 flushing per day at the following time: 5.00 hours
Day 21 to end of cycle: 1 flushing per 2 days at the following time: 5.00 hours
BROILERS (to 6-10 weeks):
Day 1 to 4: 3 flushings per day at the following times: 5.00 hours / 13.00 hours and 21.00 hours
Day 5 to 10: 2 flushings per day at the following times
: 5.00 hours and 17.00 hou
rs
Day 11 to 20: 1 flushing per day at the following time: 5.00 hours
Day 21 to end off cycle: 1 flushing per 2 days at the following time: 5.00 hours
Ending installer program
When the key is pressed, the installer’s program will end. When no keys are pressed, the installer’s program
will automatically end after 15 minutes.