25
Safety Precautions and Technical Details
DAA007EN - 11.05.2021
INSTRUCTIONS FOR SAFETY-CONSCIOUS WORK
4.1.4 Machining of bar stock
The following always applies to the machining of bar stock:
• The spindle passage must be adjusted to the diameter and profile of the bar
stock (e.g., with reduction sleeves).
• Bar stock must not protrude beyond the end of the spindle.
The following must be observed when machining bar stock:
Bar stock may only be machined in combination with a bar guide or bar feed-
er. If no bar feeder is used, the opening in the machine covering provided for
this purpose must be closed.
Manual loading of short bars is only permitted if this is carried out through a
secured feed opening on the machine side. INDEX offers suitable solutions
for this.
The machine-specific max. dimensions of the bar stock must be observed.
Manual loading of bar stock is not permitted on the C100 and C200 automatic
lathes and on all sliding headstock automatic lathes.
To Next Page
Loading...
