30
Safety Precautions and Technical Details
DAA007EN - 11.05.2021
INSTRUCTIONS FOR SAFETY-CONSCIOUS WORK
4.5 Prevention of burns and scalds
Before starting work on the machine, disconnect it safely from the power supply,
depressurize it, and allow it to cool down, as operating fluids may heat up and parts
located under covers may be hot.
If necessary, use suitable protective gloves for heated parts.
4.6 Conduct around noise
Noise emitted from the machine is measured according to the applicable directives
and regulations. For details of noise emission values, see the “Technical details”
section.
The actual noise emission at the machine depends on the production process and
the environmental conditions at the installation location.
Noise can cause hearing loss. Wear hearing protection if needed.
4.7 Conduct around laser radiation
Laser-based systems may be used on the machine. The lasers used, at maximum
intensity, conform to Class 2 (according to DINEN60825).
Caution signs are posted around the usage site of the lasers, warning against direct-
ly looking into the laser beam to avoid burns (particularly of the retina) due to laser
radiation.
To Next Page
Loading...
