36
Safety Precautions and Technical Details
DAA007EN - 11.05.2021
SAFETY INSTRUCTIONS FOR DIFFERENT LIFE PHASES
6 Safety instructions for different life phases
The phases of the machine's lifecycle are:
• Transport and packing
• Setup, installation, and commissioning
• Setup mode
• Operation (production mode)
• Maintenance, service, and repair
• Storage and decommissioning
• Disposal
6.1 Transport and packing
All covers and doors must be closed and secured.
The hydraulic system must be depressurized before transport. The vent hole in the
fluid reservoir must be closed during transport (e.g., by a screw plug).
Before transporting, the secure fastening of the batteries must be checked in the
control cabinet.
Transporting the machine with the work area door open and tools mounted poses
an increased risk of injury from protruding, sharp-edged tools. If necessary, the tools
must be wrapped with a cloth or covered with protective sleeves.
The prescribed transport locks must be used. Only suitable, trouble-free transport
means having sufficient load-carrying capacity may be used. Damaged transport
means must not be used. The transport means must be attached to the fastening
points provided for this purpose. The cargo must be secured for transport with
suitable lashing straps.
The machine must not be lifted at the control cabinet.
People must be kept away from under hanging or suspended loads. Danger areas
must be avoided and the required safety distances must be observed when the
machine is maneuvered/moved. The transport route must be kept free of obstacles
and checked for levelness, floor damages, ascending or descending slopes, etc.
The applicable rules and directives for air and sea transport must be observed.
To Next Page
Loading...
