38
Safety Precautions and Technical Details
DAA007EN - 11.05.2021
SAFETY INSTRUCTIONS FOR DIFFERENT LIFE PHASES
6.3 Setup mode
Setup mode allows movements at reduced speeds with the work area door open,
which may pose a certain risk. To reduce the risk, the following measures are
required:
• The work area door should be kept closed as much as possible, especially during
workpiece and tool movements.
• Avoid reaching into the work area when the spindle is rotating (max. rotational
speed during setup mode is 50rpm).
• The required personal safety equipment must be used, especially safety gog-
gles.
• After setup is complete, the machine must be left in a state that allows it to start
(or resume) production mode.
When the tailstock quill is actuated, there is a risk of injury from the travel of the quill
tip. The use of an insertion aid and wearing of protective gloves are recommended
for manual tooling and when using a tailstock.
In case of a power supply failure, do not reach into the work area until all spindles,
drives and tool carriers have come to a halt.
If persons are accidentally trapped or detained, observe the following:
• Locking in persons accidentally is impossible, due to the design of the machine.
• Freeing trapped persons must be carried out by qualified personnel only, by
traversing the corresponding NC axis, depending on the particular situation.
• Freeing trapped persons must take place by manual movement (using auxiliary
equipment).
Moreover, the instructions in section 4.2.1 “Changing tools” also apply.
To Next Page
Loading...
