9
Safety Precautions and Technical Details
DAA007EN - 11.05.2021
GENERAL INSTRUCTIONS FOR SAFE OPERATION
2.4 Intended use of the machine
The machine has been designed mainly for cold working of common metallic mate-
rials without requiring access to the work area during machining.
The machine is intended exclusively for use in an industrial environment.
The machine has been designed and constructed in accordance with current best
practices and generally recognized safety rules. All the required safety equipment
and protective apparatus are present.
The operational safety of the machine is only ensured if it is used as intended. If it is
not used as intended, risks may arise.
Residual risks exist even when the machine is used as intended.
For this reason, the safety notices and warnings in the operating instructions and on
the machine must be observed.
All the safety notices and warnings on the machine must be kept in a legible condi-
tion and must be replaced if necessary.
The limits specified in the technical data (e.g., maximum rotational speed or maxi-
mum turning length) must be observed.
The machine must not be operated in an explosive atmosphere.
Only one person at a time may work on the machine.
If more than one person is required in exceptional cases, the operator/owner must
appoint one person as the person responsible for coordinating the work and comply-
ing with the occupational safety regulations.
Do not walk on the machine or its auxiliary units.
If in exceptional cases it is necessary to be on the machine, this is expressly permit-
ted only when the machine is switched off.
To Next Page
Loading...
