Inficon 3000 Micro GC - Installing Heated Sample Introduction Accessories

To Next Page

To Previous Page

20 - 5

PN 074-558-P1A

3000 Micro GC Guides

15 Tilt the back of the GC module up until the mounting flange clears the alignment pins. Slide the

GC module towards the back of the instrument until it clears the inlet manifold frame and can

be lifted and removed from the front.

16 Inspect the gang block fitting on the bottom of the chassis to make sure the mating surface

is free of dust and particles.

Table 20-1 Changing a standard module (continued)

Step Description

Tilt GC module

Mounting flange

Tilt until mounting

flange is free from

aligning pins

2-channel 3000 Micro GC shown

Others are similar

Gang block, lower half

Alignment pins

Other manuals for Inficon 3000 Micro GC