20 - 8
PN 074-558-P1A
3000 Micro GC Guides
21 Lower the back of the GC module into position until there is enough clearance to position it
into place under the lip of the inlet manifold frame. At the same time, ensure the GC module inlet
fitting mates with the Swagelok fitting in the 3000 Micro GC inlet manifold.
Slide the GC module towards the front of the 3000 Micro GC until it is fully seated into the
Swagelok fitting in the 3000 Micro GC inlet manifold.
Table 20-1 Changing a standard module (continued)
Step Description
Install GC
below frame
Mate module
fittings
View from back of 3000 Micro GC
manifold
module
To Next Page
Loading...
