18
tina46e1-b (2017-12) BPG402.om
For reasons of compatibility, the expression "sensor cable" is used for all
BPG402 versions in this document, although the pressure reading of the
gauges with fieldbus interface (BPG402-SD, BPG402-SE or
BPG402-SP) is normally transmitted via DeviceNet, EtherCAT or
Profibus.
The sensor cable is required for supplying all BPG402 types with power.
It also permits access to the relay contacts of the switching functions
(→ 19, 20).
The application and length of the sensor cable have to be considered when deter-
mining the number and cross sections of the conductors (→ 11).
Open the cable connector (D-Sub, 15-pin, female).
Prepare the cable and solder/crimp it to the connector as indicated in the
diagram of the gauge used:
3.2.2.1 Making an Individual
Sensor Cable
Cable type
Procedure
To Next Page
Loading...
