26
tina60e1-a (2011-04)
Mount the gauge so that no vibrations occur. The gauge
may be mounted in any orientation. To keep conden-
sates and particles from getting into the measuring
chamber preferably choose a horizontal to upright posi-
tion and consider using a seal with centering ring and
filter. If adjustment should be possible after the gauge
has been installed, be sure to install it so that the but-
tons can be accessed with a pin.
Remove the protective lid and connect the product to the
vacuum system.
or
Clamp
Seal with centering ring
Seal with centering
ring and filter
Protective lid
Keep the protective lid.
To Next Page
Loading...
